Hot drill should be a relatively simple mechanical product. The main action is the process of scratching and ironing. And this is done by the manipulator. It is necessary to make the process of grasping and ironing well, to be efficient, and to have the quality of a single ironing drill and paste into the fabric. To ensure that the process is performed well, each action must be completed.
There are two working positions for the iron rig manipulator. One is the drill position, the other is the hot spot. When the machine is installed, it is basically in position, but there are still adjustable places.
First, the position of hot drill should be used as the benchmark.
This position is adjusted in place to determine whether the quality of the hot drill has a reliable guarantee.
To ensure that the mechanical hand of the drill press to the front position can be kept upright. The falling position happens to be at the center of the transducer work. The Angle does not adjust the limit of the cylinder, the position does not adjust the mounting bracket and so on.
The installation of the transducer must be in place, the installation should be firm, the work head can not be touched with the plate, the working face must be less than 1 mm. The main thing is to change the working face to ensure the level.
When the adjustment is in place, a good gas nozzle can be selected for the dynamic occlusion of the gas - transducer. Make specific adjustments according to the occlusion. In this way, the paste can be guaranteed to be round and round.
2. Adjust the working status of the suction position.
This position is well adjusted, which can ensure the correct and fast absorption of hot drill, improve the efficiency, and also ensure that the ironing can be carried out effectively.
After adjusting, make sure that when the manipulator is placed in the back position, it can be just out of the center of the hole in the feeding disc. Prevent the air nozzle from swinging twice over the center of the drill. The specific position should be determined according to the matching of different blanks. If necessary, this can be achieved by adjusting the limit position of the pendulum cylinder and the left and right positions of the feeding plate.
Adjust the distance between the gas nozzle and the drill hole. To enable the drill to effectively suck up, at the same time there is room to put out and do not wipe the disk. In actual work, the suction is also related to the vacuum degree and the suction flow. The problem is simple in theory. However, the actual tracheal airway placement has great influence on this.
Many machines are designed and installed because other factors such as installation, maintenance, aesthetics, and cost are considered, so they are not necessarily the best in effect. And the actual regulation, also only through the pressure reducing valve, control the vacuum generator production vacuum and the flow to adjust properly.
After the adjustment is in place, it is important to check whether the bolts of each fastening are firm. Seal the key parts. Prevent fault from running because of vibration.
It is important to note that the work of the drilling rig is a dynamic process. Due to the mechanical shock, resonance, good position in static time, there will still be some deviation in the work. If this problem exists, it can only be compensated according to the actual machine.